The JEC Axial Flow pump is unmatched in the industry for high volume / low head pumping requirements, especially when corrosive and/or abrasive solutions are involved. Mainly used in the following application:
The Axial-Flow pump generates flow by the thrust or lifts action of rotating axial vanes of the impeller. The pump has an elbow that directs the flow through the suction and out the discharge end of the pump. It can be used in the top or end suction configuration depending upon the need and Flange dimensions, the bolt circle, and holes comply with ANSI 816.5, 1508. The back pull out design (up to 14” size) allows for easy maintenance and repair as the rotating element may be removed without disturbing the pipework. The pump has wear rings as standard and lifting eye on bearing bracket.
Horizontal non-self-priming pump with back pulls out design (up to 14'' size & bigger size available on request). The 'back pull out' design allows for the maintenance of the pump without disturbing the pipework connected to the casing, or the pump alignment.
ANSI B16.5,150# SORF. - Standard
DIN - Optional
The shaft is of the wet type, which comes in contact with the pumped liquid.
Casted or fabricated elbow with precisely machined for a minimum gap between propeller and casing. Liner type cast casing also available.
- Stuffed Packing Box
- Single / Double Mach. Seal with cartridge-type arrangement
- Other available as per request
